High Power electrosurgical unit with monopolar
biopolar outlets cutlets
Handling Instructinos:
Insert three pin power cord & on/off switch light glows. Switch on the unit. Now Insert the earthplate LED, will go off and buzzer will switch off. Select the mono/bio mode by keeping monolbio switch accordingly for mono mode keep the switch towards the left side. Both the LED will glow and for bio mode keep the switch towards the right side LED will glow. Select the desired function using function switch i,e. Cut, Coag Blend, Fulg. Depending upon the function selected corresponding LEDs will glow. Insert the unipolar Handel or auto handle as per the choice. Insert the biopolar Handel & Keep the intensity minimum, increase as per the requiment. Insert the foot switch at the rear of the machine. Press the foot switch for desired function machine will work for selected function and audible sound will come out.
Salient Features (MONOPOLAR):
Main
220v
240V
3.4a R.M.S.
3.1a R.M.S.
Fuse rating
200-240V, T5, OA
100-1 20V, T I O.OA
Fuse type
20mm to IEC 127 (BS4265)
OUTPUT (MONOPOLAR):
Power
Crest
factor
Peak open circuit output voltage
Normal cut -
400W/250W
1.3
1200
Blend -
300W/200W
2.4
1800
Speciallist cut -
350W/250W
1.9
1700
Pinpoint coag -
150W
3.0
2000
Spray Coag
80W
9.0
3800
Impedance test Load:
200 ohms
Power control:
Variable amplitude controlled by front panel dials.
Preset pulse patterns slected by mode switch.
Effective carrier frequency:
700kHz squre wave
Load impedance for
maximum output power:
200 ohms
OUTPUT (BIOPOLAR):
Power
Crest
factor
Peak open circuit output voltage
Coag (max)-
50W
Variable
350
Coag (min)-
15W
Variable
200
Impedance for maximum :
Output power:
100 Ohms
Impedance test load:
100 Ohms
Power control:
Variable pulse group modulation controlled by from
panel dial. Amplitute selectable by Hi/Low Range
Button
Effective carrier frequency:
785kHz squre wave
Forceps switching
circuit:
Initial delay time to 2 seconds (rear panel control)
Maximum on time 8 second.
